Good quality Incoloy Alloys - Alloy 50 (aka Magnifer 50, Carpenter High Permeability 49, Alloy 47-50) – Herui Detail:
Description
A soft magnetic alloy, consisting of 49% Nickel, balance Iron used where high initial permeability, maximum permeability, and low core loss is needed.
Chemical Composition
| C | P | S | Cu | Mn | Si | Ni | Fe |
| ≤ | |||||||
| 0.03 | 0.020 | 0.020 | 0.20 | 0.30-0.60 | 0.15-0.30 | 49.0-50.5 | Balance |
Characters
High permeability
High magnetic flux density
Good fabrication property
Anti-rust ability
Applications
Small power transformers, micro motors, relays, choke ring and an electromagnetic clutch of core, and magnetic shield of the microphone diaphragm torque motor armature and a conducting magnet.
Equal Grades
1J50(China), 50H(Russia), PB(Japan)
Forms available
Strip, bar, wire
Product detail pictures:
Related Product Guide:
We thinks what buyers think, the urgency of urgency to act during the interests of a purchaser position of theory, allowing for much better high-quality, reduced processing costs, charges are more reasonable, won the new and outdated consumers the support and affirmation for Good quality Incoloy Alloys - Alloy 50 (aka Magnifer 50, Carpenter High Permeability 49, Alloy 47-50) – Herui, The product will supply to all over the world, such as: Orlando, Iran, South Africa, Most problems between suppliers and clients are due to poor communication. Culturally, suppliers can be reluctant to question items they do not understand. We break down people barriers to ensure you get what you want to the level you expect, when you want it. Faster delivery time and the product you want is our Criterion .
The use and maintain of the sawblade
◎ The carbide tip of sawblade is very sharp, so process of using must be prevent the carbide tip.
◎ PeriodicaI cleaning and support the machine,the spindle’s running tolerance must be less than h7.
◎ The flanges must be parallel to each other,must be of the same diameter 1/3 of the sawblade’s diameter(formuIti—rip saw blade is 1/2.
◎ When instaIIion the sawbIade,it shaII be 5-6 teeth higher than board surface．
◎ Before operation,check the firmly of the sawblade,be sure nobody in front of the machine. Do not feed of operation check whether the machine is good for operaiton. Periodical check the function of the machine,the certicaI jump is less than ±0.02MM,and the flap is less than ±0.01.
◎ After continuous use,must be removed and cleaning the sawblade,get rid of the resin and sawdust of the sawblade of both sides.Other wise it would beinfluence the effect of using the sawblade.
◎ Deposit of the sawblade,must not be layer the sawblade,it is putted in the originaI package inside.
The renovate of the sawbIade
◎ The renovate of the carbide sawblade While it no longer sharpen and the horizontaI piece coarseaess. The power of using sawblade machine obviously Increase. When process materiaI,the materiaI appearred burst. The carbide tip exhaust more than 0.02MM.
◎ For the renovate the sawblade,it shouId be grinding by the a formal company, so be sure the quality of the sawblade after renovating.
By Olivia from Italy - 2017.06.25 12:48
Factory equipment is advanced in the industry and the product is fine workmanship, moreover the price is very cheap, value for money!
By Betsy from Armenia - 2017.10.13 10:47
