Invar, Invar 36, NILO 36 & Pernifer 36 / UNS K93600 & K93601 / W. Nr. 1.3912

Short Description:


Product Detail

HOW TO USE THE SAWBLADE

Product Tags

 Description

Invar (also know as Invar 36, NILO 36, Pernifer 36 and Invar Steel) is a low expansion alloy consisting of 36% Nickel, balance Iron. Invar Alloy exhibits extremely low expansion around ambient temperatures, making Invar Alloy particularly useful in applications where minimum thermal expansion and high dimensional stability is required, such as in precision instruments like optoelectronic devices, optical and laser benches, electronics, and other kinds of scientific instruments.

Chemistry By % Weight

C  0.02%
Fe  Balance
Mn  0.35%
Ni  36%
Si  0.2%

Typical Mechanical Properties

Ultimate Tensile Strength   104,000 PSI
Yield Strength             98,000 PSI
Elongation @ Break        5.5
Modulus of Elasticity       21,500 KSI

Typical Physical Properties

Density     0.291 lbs/cu in 
Melting Point    1425° C 
Electrical Resistivity @ RT    8.2 Microhm-cm
Thermal Conductivity @ RT   10.15 W/m-k

Available Product Forms

Pipe, tube, sheet, plate, round bar, forging stock and wire.

Keywords

Invar 36, Pernifer 36, Nilo 36, Invar Steel, Iron-Nickel Alloy, Low Expansion Alloys, Precision Instruments Applications


  • Previous:
  • Next:

  • The use and maintain of the sawblade

    ◎ The carbide tip of sawblade is very sharp, so process of using must be prevent the carbide tip.

    ◎ PeriodicaI cleaning and support the machine,the spindle’s running tolerance must be less than h7.

    ◎ The flanges must be parallel to each other,must be of the same diameter 1/3 of the sawblade’s diameter(formuIti—rip saw blade is 1/2.

    ◎ When instaIIion the sawbIade,it shaII be 5-6 teeth higher than board surface.

    ◎ Before operation,check the firmly of the sawblade,be sure nobody in front of the machine. Do not feed of operation check whether the machine is good for operaiton. Periodical check the function of the machine,the certicaI jump is less than ±0.02MM,and the flap is less than ±0.01.

    ◎ After continuous use,must be removed and cleaning the sawblade,get rid of the resin and sawdust of the sawblade of both sides.Other wise it would beinfluence the effect of using the sawblade.

    ◎ Deposit of the sawblade,must not be layer the sawblade,it is putted in the originaI package inside.

    The renovate of the sawbIade

    ◎ The renovate of the carbide sawblade While it no longer sharpen and the horizontaI piece coarseaess. The power of using sawblade machine obviously Increase. When process materiaI,the materiaI appearred burst. The carbide tip exhaust more than 0.02MM.

    ◎ For the renovate the sawblade,it shouId be grinding by the a formal company, so be sure the quality of the sawblade after renovating.