New Arrival China Is Non Magnetic Stainless Steel Better - Alloy 50 (aka Magnifer 50, Carpenter High Permeability 49, Alloy 47-50) – Herui

Short Description:

Product Detail

HOW TO USE THE SAWBLADE

Product Tags

Feedback (2)

To be a result of ours specialty and repair consciousness, our corporation has won a good popularity amid consumers everywhere in the environment for Alloy K500 , Riley Williams Hss , High Speed Steel Rod , Please feel absolutely free to speak to us for organization. nd we believe we will share the best trading practical experience with all our merchants.

New Arrival China Is Non Magnetic Stainless Steel Better - Alloy 50 (aka Magnifer 50, Carpenter High Permeability 49, Alloy 47-50) – Herui Detail:

Description

A soft magnetic alloy, consisting of 49% Nickel, balance Iron used where high initial permeability, maximum permeability, and low core loss is needed.

Chemical Composition

C	P	S	Cu	Mn	Si	Ni	Fe
≤				Mn	Si	Ni	Fe
0.03	0.020	0.020	0.20	0.30-0.60	0.15-0.30	49.0-50.5	Balance

Characters

High permeability

High magnetic flux density

Good fabrication property

Anti-rust ability

Applications

Small power transformers, micro motors, relays, choke ring and an electromagnetic clutch of core, and magnetic shield of the microphone diaphragm torque motor armature and a conducting magnet.

Equal Grades

1J50(China), 50H(Russia), PB(Japan)

Forms available

Strip, bar, wire

Product detail pictures:

The use and maintain of the sawblade

◎ The carbide tip of sawblade is very sharp, so process of using must be prevent the carbide tip.

◎ PeriodicaI cleaning and support the machine,the spindle’s running tolerance must be less than h7.

◎ The flanges must be parallel to each other,must be of the same diameter 1/3 of the sawblade’s diameter(formuIti—rip saw blade is 1/2.

◎ When instaIIion the sawbIade,it shaII be 5-6 teeth higher than board surface．

◎ Before operation,check the firmly of the sawblade,be sure nobody in front of the machine. Do not feed of operation check whether the machine is good for operaiton. Periodical check the function of the machine,the certicaI jump is less than ±0.02MM,and the flap is less than ±0.01.

◎ After continuous use,must be removed and cleaning the sawblade,get rid of the resin and sawdust of the sawblade of both sides.Other wise it would beinfluence the effect of using the sawblade.

◎ Deposit of the sawblade,must not be layer the sawblade,it is putted in the originaI package inside.

The renovate of the sawbIade

◎ The renovate of the carbide sawblade While it no longer sharpen and the horizontaI piece coarseaess. The power of using sawblade machine obviously Increase. When process materiaI,the materiaI appearred burst. The carbide tip exhaust more than 0.02MM.

◎ For the renovate the sawblade,it shouId be grinding by the a formal company, so be sure the quality of the sawblade after renovating.

5mm Non-Magnetic Steel Ball